• Gauge measures clearances from .0015" to .035" and .038mm to .889mm

• Blade length: 3-5/16”

• Blade width: 1/2”

• Gauge measures clearances from .002 to .025" and .051mm to .635mm

• 2-1/2" rule and 15 blades

• Blade length: 3-5/16”

• Blade width: 1/2”

• Sizes from .004" to .027" and .10mm to .69mm

• Checks clearance measurements with a 0.002" range

• Blade length: 3"

• Sizes: .006", .008", .010", .011", .012", .013", .014", .015", .018", .019", .020"

• 1/2" x 4" blades with a 1" bend in steel holder

• Blades are offset at a right angle

• Hone and remove glaze from engine cylinders from 2" to 7"

• Adjust spring tension for positive cutting action and set diameter with spread limiter

• Includes medium grit stones no. 240

• Grit: 240

• 3 pc replacement stone set

• Use with engine cylinder hone 2833D

Includes:

• 3 arm brake, master and wheel cylinder hone - (3/4" to 2-1/2" Capacity)

• 2 arm small car brake wheel cylinder hone - (1/2" to 1-3/4" Capacity)

• 3 arm disc brake caliper honing - (1-1/4" to 3-1/2" Capacity)

• One set of 2" medium grit stones

• 10 Ton

• 3/4”-12 Acme

• ­­Includes: (1) 24” T-Handle Slide Rod, (1) 2-1/2 lbs Slide Hammer, (1) Reversible Adjusting Nut, (1) Two Jaw Yoke, (1) Three Jaw Yoke, (1) 2-Way/3-Way Slotted Crossarm, (3) 6” Reach Reversible Jaw, (3) 4” Reach Reversible Jaw, (2) 2” Reach Inside Jaw, (3) Jaw Pivot Pin , (1) Inside Hook Jaw, (1) Forcing Screw, (1) Standard Detachable Tip, (3) 3/8"-16 UNC x 3" Cap Screw, (3) 3/8"-24 UNF x 3" Cap Screw, (3) 3/8"-16 UNC x 4" Cap Screw, (1) 5 lbs Slide Hammer, (1) 12-3/4" Long Short Slide Rod, (1) Rear Axle Flange Foot, (1) Set Puller Blind Bearing, (1) Gear and Bearing Separator

• Either two or three puller jaws may be used to handle "inside" pulling jobs

• 5lbs slide hammer can be removed and used independently

• Overall Length: 27"